Print settings
It is recommended to print all parts in ABS (not ABS+), ASA or similar material to be able to withstand the high temperature environment of an enclosed printer.
Print settings should always be tuned for the material of choice and tested for sufficient strength, proper layer adhesion and mechenical load.
For stationary parts
Parts such as motor mounts, bed frame braces, etc.
| Setting | Recommended value |
|---|---|
| Layer height | 0.2mm |
| Line width | 0.4-0.6mm |
| Outside perimiters (walls) | 4 |
| Top/bottom layers | 5 |
| Infill | 40-50% cubic, triangular, gyroid or honeycomb |
For motion parts
Parts such as the carriage and X gantry joint, etc.
| Setting | Recommended value |
|---|---|
| Layer height | 0.2mm |
| Line width | 0.4-0.6mm |
| Outside perimiters (walls) | 4 |
| Top/bottom layers | 5 |
| Infill | 30-40% cubic, triangular, gyroid or honeycomb |